ePrivacy and GPDR Cookie Consent by TermsFeed Generator Skip to main content
  1. Home
  2. Product Selection by Application

Product Selection by Application

Product Features
  • Models categorized for "energy saving" have minimal steam loss
  • Tight seal even under minimal load
  • Operation not receptive to environmental influences (wind, rain/snow)
  • Initial air venting feature
Special Features for Pipe End Traps
  • Initial air venting feature
  • Swift discharge of high condensate load at start-up
  • No condensate back-up owing to continuous discharge
Operation Principle Pressure Category*1 (barg) Remark Product Series Further Reference
Continuous discharge (Energy saving model) Up to 10 With bypass valve J3S-X-BV, J3S-X-PB Steam Traps with Bypass Valve
Up to 21 - SS Series (SS1, SS3) Free Float® Steam Traps for Main Lines
With bypass valve J3S-X-RV Steam Traps with Bypass Valve
Up to 32 - SS Series (SS5) Free Float® Steam Traps for Main Lines
JH3S-B Free Float® Steam Traps (Medium / High Pressure)
QuickTrap with universal connector FS Series Free Float® Steam Traps for Main Lines
Up to 46 QuickTrap with universal connector FS Series (FS5H)
- SS Series (SS5H)
JH-B Series Free Float® Steam Traps (Medium / High Pressure)
Up to 65 SH Series Free Float® Steam Traps for Main Lines
JH-P Series Free Float® Steam Traps (Medium / High Pressure)
Up to 100 JH7RH-B
Up to 120 JH7RH-P
Cyclic operation (Energy saving model) Up to 32 - L Series Thermostatic Steam Traps
QuickTrap with universal connector FL Series
Intermittent operation Up to 13 Inline replaceable valve module A3N ThermoDyne® Disc-Type Steam Traps
Up to 46 QuickTrap with universal connector & inline replaceable valve module FP46UC PowerDyne® Disc-Type Steam Traps
Up to 65 Inline replaceable valve module P Series*2
Up to 260 HR Series

*1 Operating pressures vary between different models of the same series. For details please refer to individual Specification Data Sheets (SDS).
*2 Except P46S and P21S ver.C.

Product Features
  • No condensate back-up owing to continuous discharge
  • Self-modulating discharge as condensate load varies
  • Initial air venting feature
  • High back pressure tolerance (Condensate discharge capacity even at small differential pressure)
  • "Fail open" to avoid condensate back-up under any circumstances
End-usage Pressure Category*2 (barg) Remark Series Further Reference
Heating
  • Heat exchangers*1
  • Reboilers*1
  • Heaters, pre-heaters
  • Jacketed kettles*1
  • Autoclaves (Sterilizers, etc.)
  • Tank heaters*1
  • Other heaters
Up to 10 With bypass valve J3S-X-BV, J3S-X-PB Steam Traps with Bypass Valve
Up to 22 - SJFX Series Free Float® Steam Traps (Low Pressure)
Up to 21 JX Series
With bypass valve J3S-X-RV Steam Traps with Bypass Valve
For sterile processes LV6 Clean Steam Traps
SS5P
Up to 32 For small size equipment L Series Thermostatic Steam Traps
- JH-X Series Free Float® Steam Traps (Medium / High Pressure)
Vaporization
  • Evaporators*1
  • Tank crystallizers*1
  • Enrichment tanks*1
  • Distillers*1
  • Other vaporizers
Up to 46 - JH-B Series
Up to 32 Up to 400°C SJHB Series
Up to 65 - SH Series
JH-P Series
Up to 100 JH7RH-B
Up to 120 JH7RH-P
Drying
  • Hot air dryers
  • Presses
  • Other dryers
Up to 32 - JL Series Large Capacity Float Steam Traps
Up to 46 JL15 Series
Up to 32 Up to 400°C SJHB Series Free Float® Steam Traps (Low Pressure)
  • Cylinder dryers, roll dryers
  • Corrugated folding presses, etc.
Up to 22 - SJFX Series
Up to 21 JX Series
Up to 32 For small size equipment L Series Thermostatic Steam Traps
- SJHX Series Free Float® Steam Traps (Medium / High Pressure)
*1 Depending on the operation condition, the indicated equipment may be subject to "stall" (see *3 below). In such cases, GT Series PowerTraps are required. GT Series PowerTraps are steam traps that feature a pump function. GT Series PowerTraps

*2 Operating pressures vary between different models of the same series. For details please refer to individual Specification Data Sheets (SDS).

*3 "Stall" is a phenomenon where the internal pressure of an equipment falls below the back pressurae on the outlet side, resulting in back-up of condensate that cannot be discharged by conventional steam traps. "Stall" can cause damage such as uneven/incomplete product heating, corrosion and waterhammer.

Product Features
  • No condensate back-up owing to continuous discharge
  • Self-modulating discharge as condensate load and pressure changes
  • Initial air venting feature
  • Quiet operation
End-usage Pressure Category*2 barg Remark Series Further Reference
  • Air conditioners / air heaters*1
  • Unit heaters
  • Plate heat exchangers
  • Strip heaters*1
  • Other heaters and air conditioners
Up to 10 With bypass valve J3S-X-BV, J3S-X-PB Steam Traps with Bypass Valve
Up to 22 - SJFX Free Float® Steam Traps (Low Pressure)
Up to 21 JX Series
With bypass valve J3S-X-RV Steam Traps with Bypass Valve
Up to 32 For small size equipment L Series Thermostatic Steam Traps
- SJHX Series Free Float® Steam Traps (Medium / High Pressure)
*1 Depending on the operation condition, the indicated equipment may be subject to "stall" (see *3 below). In such cases, GT Series PowerTraps are required. GT Series PowerTraps are steam traps that feature a pump function. GT Series PowerTraps

*2 Operating pressures vary between different models of the same series. For details please refer to individual Specification Data Sheets (SDS).

*3 "Stall" is a phenomenon where the internal pressure of an equipment falls below the back pressure on the outlet side, resulting in back-up of condensate that cannot be discharged by conventional steam traps. "Stall" can cause damage such as uneven/incomplete product heating, corrosion and waterhammer.

Product Features
  • Models categorized as "energy saving" have minimal steam loss
  • Tight seal even under minimal load
  • Operation not receptive to environmental influences (wind, rain/snow)
Special Features for Measurement Instruments
  • Small and lightweight construction
End-usage Control Temperature Category Remark Series Further Reference
Insulation jackets - - SS Series Free Float® Steam Traps for Main Lines
L Series Thermostatic Steam Traps
A3N ThermoDyne® Disc-Type Steam Traps
P Series PowerDyne® Disc-Type Steam Traps
QuickTrap with universal connector FS Series Free Float® Steam Traps for Main Lines
FL Series Thermostatic Steam Traps
FP46UC PowerDyne® Disc-Type Steam Traps
Pipe trace heating Controlled temperature above 80°C - SS Series Free Float® Steam Traps for Main Lines
L Series Thermostatic Steam Traps
A3N ThermoDyne® Disc-Type Steam Traps
P Series PowerDyne® Disc-Type Steam Traps
QuickTrap with universal connector FS Series Free Float® Steam Traps for Main Lines
FL Series Thermostatic Steam Traps
FP46UC PowerDyne® Disc-Type Steam Traps
Controlled temperature up to 80°C Utilizes sensible heat LEX3N-TZ Temperature Control Steam Traps
Instrumentation trace heating Controlled temperature above 80°C - P21S ver.C PowerDyne® Disc-Type Steam Traps
P46S
LV Series Thermostatic Steam Traps
Controlled temperature up to 80°C Utilizes sensible heat LEX3N-TZ Temperature Control Steam Traps